Whirlpool XCGM2765 설치 지침 매뉴얼 - 페이지 10

{카테고리_이름} Whirlpool XCGM2765에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool XCGM2765 23 페이지. Commercial gas or electric dryer

INSTALLING LEVELING LEGS

1. Prepare dryer for leveling legs

NOTE: Slide dryer onto cardboard or hardboard before moving

to avoid damaging floor covering.

Using two or more people, move dryer to desired installation

location.

Take tape off front corners of dryer. Open dryer and remove

the literature and parts packages. Wipe drum interior with a

damp cloth to remove any dust.

Take two cardboard corners from the dryer carton and place

them on the floor in back of the dryer. Firmly grasp the body of

the dryer and gently lay it on its back on the cardboard corners.

2. Screw in leveling legs

Examine leveling legs and find diamond

marking. Screw legs into leg holes by

hand. Use an adjustable wrench or

25 mm (1") hex-head socket wrench

to finish turning legs until diamond

marking is no longer visible. Then fit

a covered foot boot over each leg foot.

To protect the floor, use a large piece of cardboard from the

dryer carton. Stand dryer up on the cardboard. Slide the dryer

until it is close to its final location. Leave enough room for

electrical connection and to connect the exhaust vent.

A longer leveling foot is available if needed on extremely sloped

floors, Part Number 279810.

Diamond

Marking

Foot