Whirlpool YGEW9250PW0 사용 및 관리 매뉴얼 - 페이지 10
{카테고리_이름} Whirlpool YGEW9250PW0에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool YGEW9250PW0 40 페이지. Electronic electric dryer
페이지 인쇄Check t helevelness ofthedryer. Check l evelness first
side toside, t hen front t oback.
Ifthedryer i snotlevel, propupthedryer u sing awood block.
Use awrench t oadjust thelegs upordown andcheck again f or
levelness.
NOTE: It might b enecessary tolevel thedryer a gain after i thas
been moved i ntoitsfinal p osition.
1. Using a 4"(10.2 cm) c lamp, connect vent t oexhaust outlet i n
dryer. Ifconnecting toexisting v ent, m ake sure thevent i s
clean. The dryer v ent m ust f itover t hedryer e xhaust outlet
andinside theexhaust hood. M ake sure thevent i ssecured
toexhaust hood witha4"(10.2 cm) c lamp.
2. Move dryer i ntofinal p osition. Donotcrush orkinkvent.
Make sure dryer i s level.
3. (On gasmodels) Check t obesure there arenokinks inthe
flexible g asline.
1. Check t obesure allparts arenowinstalled. Ifthere isan
extra part, g oback through t hesteps toseewhich step was
skipped.
2. Check t obesure youhave allofyour t ools.
3. Dispose ofallpackaging materials.
4. Check t hedryer's f inal l ocation. Besure thevent i snot
crushed o rkinked.
5. Check t obesure thedryer i slevel. S ee "Level Dryer."
6. Plug intoagrounded outlet. Turn power o n.
7. Remove theblue protective filmontheconsole a ndany tape
remaining onthedryer.
8. Read "Dryer Use."
9. Wipe thedryer d rum interior thoroughly witha damp cloth to
remove anydust.
10.Setthedryer o nafullheat c ycle (not a naircycle) for
20minutes a nd start t hedryer.
If the dryer will not start, check the following:
•
Controls are set in a running or "On" position.
•
Start button has been pushed firmly.
•
Dryer is plugged into a grounded outlet.
•
Electrical supply is connected.
•
House fuse is intact and tight, or circuit breaker has not
tripped.
•
Dryer door is closed.
11. When the dryer has been running for 5 minutes, open the
dryer door and feel for heat.
If you do not feel heat, turn the dryer off and check the
following:
•
There may be 2 fuses or circuit breakers for the dryer. Check
to make sure both fuses are intact and tight, or that both
circuit breakers have not tripped. If there is still no heat,
contact a qualified technician.
NOTE: You may notice a burning odor when the dryer is first
heated. This odor is common when the heating element is first
used. The odor will go away.
10