Whirlpool YLEW0050PQ0 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Whirlpool YLEW0050PQ0에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool YLEW0050PQ0 32 페이지. 240.volt electric dryer

페이지 인쇄

4. Turn thecoupling a ndexhaust vent a ssembly

counterclockwise

intheexhaust hole ontheback ofthe

dryer.

5. Make sure theexhaust vent i splaced i nside t heexhaust hood

and thensecured totheexhaust hood witha4"(10.2 cm)

vent c lamp.

6. Move dryer i ntoitsfinal l ocation. Donotcrush orkinkvent.

Check t helevelness ofthedryer. Check l evelness first

side toside, t hen front t oback.

Ifthedryer i snotlevel, propupthedryer u sing awood block.

Use awrench t oadjust thelegs upordown andcheck again f or

levelness.

1. Check t hatallparts arenow installed. Ifthere isanextra part,

goback through t hesteps toseewhich step wasskipped.

2. Check t hatyouhave allofyourtools.

3. Dispose of/recycle allpackaging materials.

4. Check t hedryer's f inal l ocation. Besure thevent i snot

crushed o rkinked.

5. Check t hatthedryer i slevel. See "Level Dryer."

Electrical

Shock Hazard

Plug into a grounded

4 prong outlet.

Failure to do so can result in death or electrical

shock.

6. Plug into a grounded 4 prong outlet,

7. Remove the clear protective film on the front edge and any

tape remaining on the dryer.

8. Read "Dryer Use,"

9. Wipe the dryer drum interior thoroughly with a damp cloth to

remove any dust.

10. Set the dryer on a full heat cycle (not an air cycle) for

20 minutes and start the dryer.

If the dryer will not start, check the following:

•

Controls are set in a running or "On" position.

•

Start button has been pushed firmly.

•

Dryer is plugged into a grounded outlet.

•

Electrical supply is connected.

•

Household fuse is intact and tight, or circuit breaker has

not tripped.

•

Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and

close the door.

If you do not feel heat, turn off the dryer and check the

following:

•

There may be 2 household fuses or circuit breakers for the

dryer. Make sure both fuses are intact and tight, or that both

circuit breakers have not tripped. If there is still no heat,

contact a qualified technician.

NOTE: You may notice a burning odor when the dryer is first

heated. This odor is common when the heating element is first

used. The odor will go away.