Whirlpool YWED7500VW2 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Whirlpool YWED7500VW2에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool YWED7500VW2 40 페이지.

페이지 인쇄

INSTALLATION INSTRUCTIONS

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting installation.

Tools needed:

Flat-blade screwdriver

Level

Torx T20

Security

†

screwdriver

Caulking gun and

compound (for installing

new exhaust vent)

Parts supplied:

Parts package is located in dryer drum. Check that all parts

are included.

NOTE: Do not use leveling legs supplied if installing with

a pedestal or a stack kit.

Coupling

® TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.

†

Wood block

Tin snips (new vent

installations)

Adjustable wrench that

opens to 1" (25 mm) or

hex-head socket wrench

Parts needed:

(Not supplied with dryer)

Vent clamps

Vent elbows and ductwork

Additional parts may be required, depending on your

installation. Check local codes. Check existing electrical

supply and venting. Read "Electrical Requirements" and

"Venting Requirements" before purchasing parts.

Options:

(Not supplied with dryer)

Pedestal

You may order a pedestal

separately for this dryer. This

pedestal will add about 12"

(305 mm) to the height of your unit

for a total height of approximately

45" (1.14 m).

To order, call the dealer from

whom you purchased your dryer

or refer to the "Assistance or

Service" section of this manual.

Ask for Model Number LAB0050PQ.

Stack kit

Are you planning to stack your washer and dryer? Your dryer

is shipped with Stack Kit W10178021, which fits Whirlpool

washer models starting with WFC.

If you have any other washer model, call the dealer from whom

you purchased your dryer or refer to the "Assistance or Service"

section of this manual.