Whirlpool YWED8200YW0 설치 지침 매뉴얼 - 페이지 10

{카테고리_이름} Whirlpool YWED8200YW0에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool YWED8200YW0 36 페이지. Gas dryer

페이지 인쇄

1. Troubleshooting

Alternate installations for close clearances

Venting systems come in many varieties. Select the type best

for your installation. Two close-clearance installations are shown.

Refer to the manufacturer's instructions.

A. Over-the-top installation (also available with one offset elbow)

B. Periscope installation

NOTE: The following kits for close clearance alternate

installations are available for purchase. Contact your local dealer.

Over-the-Top Installation:

■

Part Number 4396028

Periscope Installation (For use with dryer vent to wall vent

■

mismatch):

Part Number 4396037 - 0" (0 mm) to 18" (460 mm) mismatch

Part Number 4396011 - 18" (460 mm) to 29" (737 mm)

mismatch

Part Number 4396014 - 29" (737 mm) to 50" (1270 mm)

mismatch

Special provisions for mobile homes:

Exhaust vent must be securely fastened to a noncombustible

portion of mobile home and must not terminate beneath the

mobile home. Terminate exhaust vent outside.

Moblie Home Exhaust installation

Determine vent path:

Select route that will provide straightest and most direct

■

path outdoors.

Plan installation to use fewest number of elbows and turns.

■

When using elbows or making turns, allow as much room

■

as possible.

Bend vent gradually to avoid kinking.

■

Use as few 90° turns as possible.

■

Determine vent length and elbows needed for best

drying performance:

Use following Vent System Chart to determine type of vent

■

material and hood combinations acceptable to use.

NOTE: Do not use vent runs longer than those specified

in Vent System Chart. Exhaust systems longer than those

specified will:

Shorten life of dryer.

■

Reduce performance, resulting in longer drying times

■

and increased energy usage.

The Vent System Chart provides venting requirements that

will help achieve best drying performance.

Number of

90° elbows

NOTE: Bottom exhaust installations have a 90° turn inside the

dryer. To determine maximum exhaust length, add one 90° turn

to the chart.

INSTALL VENT SYSTEM

Install exhaust hood and use caulking compound to seal

exterior wall opening around exhaust hood.

Vent System Chart

Type

Box/louvered

of vent

Rigid metal

64 ft. (20 m)

Rigid metal

54 ft. (16.5 m)

Rigid metal

44 ft. (13.4 m)

Rigid metal

35 ft. (10.7 m)

27 ft. (8.2 m)

Rigid metal

Install exhaust hood

(305 mm)

Angled

hoods

58 ft. (17.7 m)

48 ft. (14.6 m)

38 ft. (11.6 m)

29 ft. (8.8 m)

21 ft. (6.4 m)

12" min.

(305 mm)

12" min.