Whirlpool YWED9050XW 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Whirlpool YWED9050XW에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool YWED9050XW 16 페이지.

페이지 인쇄

TOOLS AND PARTS

Gather the required tools and parts before starting installation.

Tools needed for all installations:

Flat-blade screwdriver

Wire stripper (direct wire

installations)

1/4" nut driver

(recommended)

Tape measure

Level

Adjustable wrench that

opens to 1" (25 mm) or

hex-head socket wrench

INSTALLATION REQUIREMENTS

#2 Phillips screwdriver

Tin snips (new vent

installations)

Vent clamps

Pliers

Caulking gun and compound

(for installing new exhaust vent)

Utility knife

Tools needed for gas installations:

8" or 10" pipe wrench

Pipe-joint compound

resistant to LP gas

Parts supplied (all models):

Leveling legs (4)

Parts supplied (steam models):

"Y" connector

Long inlet hose

Parts package is located in dryer drum. Check that all parts

are included.

NOTE: If installing dryer on pedestal, do not use leveling legs.

Optional Equipment: (Not supplied with dryer)

Refer to your Use and Care Guide for information about

accessories available for your dryer.

Parts needed: (Not supplied with dryer)

Check local codes. Check existing electrical supply and venting.

See "Electrical Requirements" and "Venting Requirements"

before purchasing parts.

Check code requirements. Some codes limit, or do not permit,

installing dryer in garages, closets, mobile homes, or sleeping

quarters. Contact your local building inspector.

8" or 10" adjustable wrench

(for gas connections)

Short inlet hose

Rubber washer