Whirlpool YWED94HEAC 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Whirlpool YWED94HEAC에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool YWED94HEAC 22 페이지. Gas dryer

페이지 인쇄

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting installation.

Tools needed for all installations:

Flat-blade screwdriver

1/4" and 5/16" nut driver

(recommended)

Tape measure

Utility knife

Caulking gun and compound

(new vent installations)

Tools needed for gas installations:

8" or 10" pipe wrench

Pipe-joint compound

resistant to LP gas

#2 Phillips screwdriver

Level

Pliers

Tin snips (new vent installations)

Adjustable wrench that opens to

1" (25 mm) or hex-head socket wrench

8" or 10" adjustable wrench

(for gas connections)

Parts supplied (all models):

Leveling legs (4)

Parts supplied (steam models):

"Y" connector

Parts package is located in dryer drum. Check that all parts

are included.

NOTE: Do not use leveling legs supplied with dryer if installing

with a pedestal or a stack kit.

Parts needed:

(Not supplied with dryer)

Vent clamps

■

Vent elbows and vent work

■

Parts needed (steam models):

2' (0.6 m) inlet hose

Additional parts may be required, depending in your installation.

Check local codes. Check existing electrical supply and venting.

Read "Electrical Requirements" and "Venting Requirements"

before purchasing parts.

Optional Equipment:

(Not supplied with dryer)

Refer to your Use and Care Guide for information about

accessories available for your dryer.

5' (1.52 m) inlet hose

and rubber washer