Whirlpool YWED9500E 설치 지침 매뉴얼 - 페이지 19

{카테고리_이름} Whirlpool YWED9500E에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool YWED9500E 26 페이지. Gas and electric dryer

Attach short hose and

"Y" connector

Attach 2 ft (0.6 m) inlet hose to cold water faucet. Screw on

coupling by hand until it is seated on faucet. Then attach "Y"

connector to male end of the 2 ft (0.6 m) inlet hose. Screw on

coupling by hand until it is seated on connector.

Tighten couplings

Using pliers, tighten the couplings with additional two-thirds

turn.

NOTE: Do not overtighten. Damage to the coupling can result.

Attach long hose to "Y"

connector and tighten couplings

Attach dryer 5 ft (1.5 m) inlet hose ends to the "Y" connector.

Attach washer cold inlet hose to other side of "Y" connector.

Screw on coupling by hand until it is seated on connector.

Using pliers, tighten the couplings an additional two-thirds

turn.

NOTE: Do not overtighten. Damage to the coupling can result.

Attach long hose to dryer fill

valve and tighten coupling

Fill Valve

Gas Valve

Attach other end of long hose

to fill valve at bottom of dryer

back panel. Screw on coupling

by hand until it is seated on fill

valve connector. Using pliers,

tighten the couplings an additional

two-thirds turn.

NOTE: Do not overtighten. Damage

to the coupling can result.

Turn on cold water faucet

Check that the water faucet is turned on.

Check for leaks

Check for leaks around "Y" connector, faucets, and hoses.

(115 mm)

(150 mm)