Calandra Racing Concepts Battle Axe 2.0 조립 설명서 - 페이지 4

{카테고리_이름} Calandra Racing Concepts Battle Axe 2.0에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Calandra Racing Concepts Battle Axe 2.0 16 페이지. 1:10th oval weapon from team crc

페이지 인쇄

Rear X-Pod

Bag 3

1 - Insert a 1/4" red button head screw [22]

through the bottom of the front hole on the

graphite top plate [17] so that the threads

point upward. Slide two washers [8] over the

screw and then tighten with the red female

ballstud [18].

2 - Repeat this process for the 2 outer holes

behind the front hole, except you will use the

3/16" red button head screws [16], and no

washers will be used.

3 - Install the Graphite X-brace [19] to the

back of the two aluminum pods [20 & 21].

Use 4 1/4" red button head screws [22] to

attach the graphite piece to the aluminum.

4 - Attach the assembled top plate to the

motor plate [20] using 2 1/4" red button head

screws [22].

Red Aluminum

4-40 x 3/16"

Female Ballstud

Red Button Head

Graphite

Top Plate

4-40 x 1/4"

Red Button Head

Graphite

Motor Plate

X-brace

1 - Install the completed rear pod to the chassis sub-assembly

using 4 red alum flat head screws [23]. Keep an eye on these

screws during the first few runs of your car. They tend to

loosen until they take a "set" and then they'll stay tight.

We do NOT recommend using thread lock on aluminum to

aluminum applications. They will stay tight after being re-

tightened once or twice.

2 - Tighten the top plate to the hex standoff [15] using a red

button head screw [22].

4-40 x 1/4"

Washer

Red Alum FH

Micro Left Side

Pod Plate