Calandra Racing Concepts Battle Axe 2.0 조립 설명서 - 페이지 7

{카테고리_이름} Calandra Racing Concepts Battle Axe 2.0에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Calandra Racing Concepts Battle Axe 2.0 16 페이지. 1:10th oval weapon from team crc

페이지 인쇄

Center Shock Mount

Bag 6

1 - Assemble shock mount as shown by inserting two

steel 4-40 x 5/8" cap head screws [27] through a graphite

plate [25], then through the aluminum mount [26], and

through the other graphite plate. Secure the screws and

tighten the assembly with two red locknuts [9].

2 -

The ball shown in the picture is a part of the center

shock, and we will get to this in bag 7.

third screw through one of the shock mount holes, slide

the washers over the screw, and lightly tighten with the

third locknut, just so we don't lose the parts. Don't

squeeze the graphite plates together.

Center Shock

Bag 7

Aluminum Shock /

Antenna Mount

Graphite Shock

Mount Plates (x2)

For now, slide the

Build the center shock per the instructions included in Bag 7.

Once the shock is built, refer to the diagram below.

1 - Remove the screw, nut, and 2 washers from the shock mount, that we had temporarily bolted

on earlier.

2 - Slide the screw through one of the graphite plates, and place one of the washers over the

screw. Now insert the screw through the shock ball. Insert the second washer between the shock

and the second graphite plate, and push the screw the rest of the way through the second plate.

Tighten the assembly with the red locknut.

3 - Using pliers, gently squeeze the plastic rod end over the ball stud on the rear top plate. Do not

force the rod end over the ball by pushing down on it or you could damage the top plate.

4-40 x 5/8"

Steel Cap Head

Brass Washer

1 - Attach the completed center shock mount to the

chassis [6] using two 4-40 x 1/4" red FH screws [23] in

the holes shown in the diagram.

2 - Insert the antenna tube into the vertical hole in the

center shock mount and then tighten the clamp with a

4-40 x 1/4" steel cap head screw [29].

4-40 x 1/4"

Red Alum FH

4-40 x 1/4"

Steel Cap Head

Red Locknut

NOTE - The ball

pictured here is not

included in this step.