Calandra Racing Concepts WTF1 조립 설명서 - 페이지 9

{카테고리_이름} Calandra Racing Concepts WTF1에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Calandra Racing Concepts WTF1 11 페이지. Calandra racing concepts 1/10th formula 1 car

페이지 인쇄

Front End -

1542 - F1 Upper Arms

continued...

Bag F

1550 - Caster shims (10)

1550

1545

Front End -

3355 - Alum Vertical

continued...

Mount Set-Red

1553 - Graphite Servo

Bag F

Mount Plate-F1

The mounting "ears" on the servo will

need to be trimmed off the bottom of the

servo case for the servo to sit flat on the

chassis.

Servo Alignment - Assemble the servo

saver, servo saver brace, and ball studs

as shown in the diagram. Then when

using the two-sided servo tape to hold

the servo between the plates, line up the

servo case flush with the edge of the

graphite plates and this will give you just

the right amount of "tie-rod sweep"

(steering ackerman).

1.192"

1317

1582 - E-Clip for

Upper Hinge Pin

1545 - F1 Upper

Hinge Pin

1544 - F1 Upper Arm /

Steering Block Ball

1542

The front wing (not included) would slide in here

between the chassis and the plastic lower arm

mount. The further forward of the two front end

screws will pass through the front wing before

passing through the upper arm mount and into the

M4 locknut.

1424 - 4-40 x 1/4"

Flat Head

If installing an Airtronics/Sanwa 94761 or

SRGHR, then no graphite plates or

aluminum mounts are needed. Bolt down

the servo to these two holes.

1231

3221 - Steering Block Set

1496 - M4 x 30mm

Front End Screw

1544

3221

3376 - Molded Servo

Saver Brace

1436 - 4-40 x 3/8"

13615 -

Red Low-

Profile Ball

(Servo Tape - Not Included)

1499 - M4

Locknut

1496

1317 - 42mm Steering

Tie-Rod

Button Head

1231 - Plastic Ball Cups

1553

3376

3355