CALB CA400 제품 사용 설명서 - 페이지 9

{카테고리_이름} CALB CA400에 대한 제품 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CALB CA400 10 페이지.
CALB CA400에 대해서도 마찬가지입니다: 제품 사용 설명서 (7 페이지)

Product User Manual

Step 2: Install grouping separators as figure 3.

Lower protector

Installation requirements:

Push the battery grouping separators by one side, and clamp the battery by the snap on both sides without falling down. The grouping

separator should be fitted with the upper and lower separator edge without warping.

Step 3: Install upper protector as figure 4.

Upper protector

Lower separator

Installation requirements:

Push the battery grouping separator by one side, and clamp the battery by the snap on both sides without falling down. The grouping

separator should be fitted with the upper and lower separator edge without warping.

Press the upper protector into the battery and make sure it tight and fit with the battery, with no loose connection between protector

and battery.

Grouping separator

Figure 3

Grouping separator

Figure 4

Step 4: Install the pole protector as figure 5.

Pole protector

Upper protector

Lower separator

Installation requirements:

Press the pole protector into the upper protector from up to down, and clamp the protectors by the snaps on both sides without

falling down.

After installation, it should be fixed tight and fully fitted between the battery and protectors with no loosening. The completion of

protectors' installation should be like figure5.

2 .2 CAM series battery pack protection components installation

When the protection components for single batteries are installed fully, you can install the battery packs as you need. Installation of

this section includes fastening clamps, screws, nuts, bus bars, and pole protectors.

Screw

Nut

Fastening clamp

Grouping separator

Figure 5

Pole protector

Bus bar

Figure 6