CLARCOR UAS VP Series 소유자 매뉴얼 - 페이지 11

{카테고리_이름} CLARCOR UAS VP Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CLARCOR UAS VP Series 20 페이지. Versatile/portable cartridge dust collector

페이지 인쇄

Revised 08/09

1. Collected dust may be a potential fire hazard. Refer

to Section 1 of this manual.

2. Wear appropriate protective clothing.

3. Be environmentally aware of collected dust and its

proper disposal.

4. Press unit function switch to OFF position. Unplug

unit from electrical power source.

5. Disconnect compressed air supply to air manifold

inlet and bleed air supply from manifold.

6.1 FILTER REMOVAL AND REPLACEMENT

As the V Series unit operates and the filter accumulates

dust, the flow rate of the unit will deteriorate. When the

pressure drop across the filter continuously reads

between 2"-3" or flow drops off to the point where the

dust generation process cannot adequately be

controlled, then it is time to change filters. To change

filters follow these steps:

1. Remove filter access cover by unscrewing the

retaining knob (see Figure 8). Tilt cover back away

from unit when freed from the retaining nut to trap

any fugitive dust on the inside of the access cover.

Dump dust into suitable disposal container.

2. Move filter from side to side to break gasket seal

between the filter and the tubesheet. Rotate the filter

180° to allow dust on top of the cartridge to fall into

the dust drawer.

3. Slide filter out along support rods and transfer to

suitable disposal container. Empty dust drawer as

described in Section 6.2.

4. Inspect tubesheet and make sure the gasket sealing

area is free of dust to ensure a proper seal.

5. Install a new filter element. Clean access cover

gaskets and reinstall cover by tightening the knob

securely to the retaining nut until the gasket is

adequately compressed.

Figure 8. Cartridge Filter Removal

6.2 DUST DRAWER REMOVAL

1. To access and remove the dust drawer located at the

base of the V Series unit, you must first unseal the

drawer by pulling the drawer release handle (see

Figure 8) toward the filter access side of the cabinet.

The drawer will move down and can be pulled out of

the front of the cabinet.

2. Dispose of the collected dust into a suitable

container. Any dust in the cabinet that was not

contained in the dust drawer should be vacuumed

out and disposed of.

3. Replace dust drawer by fully inserting into unit, and

reseal the drawer by pushing the drawer release

handle toward the control panel.

The collector should now be ready to operate. Reconnect

electrical power and air supply. Go through initial start-up

checklist to ensure proper unit performance.

6.3 AFTER-FILTER REMOVAL/INSTALLATION

If your unit was ordered with a HEPA or carbon after-filter,

there will be an additional filter housing bolted to the

discharge side of the V Series unit. The following steps will

allow you to remove and replace the after-filter as shown in

Figure 9. NOTE: After-filter housings for portable units (VP)

have a push handle located on the top of the housing.

1. Release the four draw latches located on the filter

housing to release the seal of the after-filter.

2. Remove the exhaust screen.

3. The after-filter will slide out of the housing as shown

in Figure 9. Keep in mind that the filter weight may

significantly increase from the collected material.

Dispose of filter properly.

61-10039-0003

Cartridge Dust Collector

Figure 9. After-Filter Removal

V SERIES

61-10040-0001