ABB FEPL-02 Ethernet POWERLINK 빠른 시작 매뉴얼
{카테고리_이름} ABB FEPL-02 Ethernet POWERLINK에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB FEPL-02 Ethernet POWERLINK 2 페이지. Ethernet powerlink adapter module
ABB FEPL-02 Ethernet POWERLINK에 대해서도 마찬가지입니다: 빠른 설치 및 시작 매뉴얼 (2 페이지)
페이지 인쇄
—
OPTIONS FOR ABB DRIVES
FEPL-02 Ethernet POWERLINK adapter
module
Quick installation and start-up guide
Safety instructions
WARNING! Obey the safety instructions of the drive. If you ignore them, injury or death, or
damage to the equipment can occur.
Mechanical installation
1. Pull out the lock.
2. Install the module carefully to an option
module slot of the drive. See the drive
hardware manual.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m
using a Torx TX10 screwdriver.
WARNING! Do not use excessive force, or leave the screw too loose. Over-tightening can
damage the screw or module. A loose screw decreases the EMC performance, and can
cause an operation failure.
Electrical installation
Layout of the module
1
6
2
3
5
4
1
No.
Description
1
Lock
2
Mounting and grounding screw
3
RJ-45 connector [X1]
4
RJ-45 connector [X2]
5
Diagnostic LEDs
6
MAC address
3
4