Firepower Klover Bi-Fire Utility 운영 및 유지보수 - 페이지 5

{카테고리_이름} Firepower Klover Bi-Fire Utility에 대한 운영 및 유지보수을 온라인으로 검색하거나 PDF를 다운로드하세요. Firepower Klover Bi-Fire Utility 5 페이지.

If you let the hopper run out of pellets then the display will read AL 6 – NO PELL. ALARM.

The first things to do are fill up the hopper and check that the crucible is clean. If there

are pellets in the crucible then empty it (not into the hopper) and check that the holes are

clear. Now you need to re-start it. Do not re-start it without checking the crucible first.

If the display reads FINAL CLEANING when you press the Stop/Start button then leave it

a bit longer to cool down. When that display reads Off then press and hold the Stop/Start

button again. It will then display start and it will run through the ignition cycle.

If for any reason an ignition was to fail then the display will read AL – 5 NO IGNIT.

ALARM. If that were to happen then clean out the crucible and check that it is seated

properly. Then you need to re-start it by pressing the Stop/Start button. As above, if the

display reads FINAL CLEANING then you'll need to give it time to cool itself down before

you press the Stop/Start button again.

5 | Page