FirePro FP-08450 사용자 설명서 - 페이지 3

{카테고리_이름} FirePro FP-08450에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FirePro FP-08450 20 페이지. Fire detection and activation system

Introduction

1.1

The FirePro FP-08450 Fire Control Panel is a combined detection and extinguishant system,

and is compliant for use in marine (AMSA NSCV).

The FIP (fire indicator panel) incorporates:

2x Detection circuits;

1x Extinguishing Discharge circuit;

1x Siren/Strobe circuit;

Programmable Activation (automatic and/or manual);

Fault Monitoring system;

Isolation Function.

1.2

All FirePro Aerosol Generators use the latest generation FPC solid compound. Upon activation,

the solid compound is transformed into a rapidly expanding, highly efficient gas, based on

Potassium salts. It does not deplete oxygen levels. The built-in fail-safe activation system

ensures operation of the generators when required, even if everything else fails. At 300⁰C the

FPC block changes to a potassium-based gas to extinguish the fire.

1.3

If a fire occurs, equipment operators should do the following:

1. Detection will initiate an alarm condition on the FirePro System

2. The siren/strobe will operate and if shutdown relays have been installed, equipment

shutdown will be initiated.

3. Evacuate all personnel from the risk area.

4. Close all hatches and openings, and shutdown engines and any extraction fans or vents.

5. Manual Activation: Press and hold both mode switches continuously for 5 seconds to

activate the system.

6. Remote Activation Switches: The control panel will automatically begin the activation

sequence when remote activation switches (where installed) are pushed (Det Circuit 1).

7. Keep the FirePro suppression gas within the risk until the fire is extinguished and not able

to re-ignite.

8. Do not start engine or fans until the fire is extinguished. Operating the exhaust fans will

enable the gas to escape the risk area and could allow the fire to re-ignite.

9. Do not enter the risk until it has been rendered safe.

10. Recommended clean up after discharge is with soapy water and a cleaning agent based on

citric acid.

11. Following a discharge, replace all installed FirePro Generators.

Ozone Depletion Potential (O.D.P.) = 0

Atmospheric Life Time (A.L.T.) = 0

Global Warming Potential (G.W.P.) = 0

Non-corrosive & Non-toxic

Page | 3