Whirlpool 2510498 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 8

{카테고리_이름} Whirlpool 2510498에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 2510498 28 페이지. Wall-mount canopy range hood

페이지 인쇄

Install Range Hood

1. Remove screws from wooden shipping supports. Properly

dispose of shipping materials.

2. Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

3. Remove the grease filter. See "Range Hood Care" section.

4. Level the range hood and tighten upper mounting screws.

5. Install (2) 5 x 45 mm #2 Phillips lower mounting screws and

tighten. Use the optional wall anchors if needed.

Connect Vent System

1. Install vent transition (A) on top of hood (if removed for

shipping) with (2) 3.5 x 9.5 mm T10 sheet metal screws. Use

T10 Torx

drive (or T10 adapter provided) to tighten.

A. Vent transition

B. 3.5 x 9.5 mm screw location

For vented installations only:

1. Fit vent system over transition piece.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket using

(4) 4.2 x 8 mm T20

adapter provided) to tighten.

2. Measure from the bottom of the air deflector to the bottom of

the hood outlet.

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

3. Cut the duct to the measured size "X.".

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over the exhaust

outlet from the hood.

7. Reassemble the air deflector to the duct cover bracket with

the 4 assembly screws.

8. Seal connections with vent clamps.

screws. Use a T20

A. Assembly screws

B. Air deflector

C. Duct cover bracket

D. Vent duct

E. Exhaust outlet

Torx

drive (or T20