Whirlpool 99043751B 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Whirlpool 99043751B에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 99043751B 24 페이지. 24" (58 cm), 30" (76.2 cm), 36" (91.4 cm) range hood

페이지 인쇄

4. Use saber or keyhole saw to cut a 6¹⁄₄" (15.9 cm) diameter

opening.

6 ¹/₄" (15.6 cm) diam.

*4³⁄₄"

(12.1 cm)

5. Install vent through the vent opening in upper cabinet or wall.

Complete venting system according to the selected venting

method. See "Venting Requirements" section.

6. Use caulking to seal exterior wall or roof opening around the

cap.

Install Range Hood

1. Remove terminal box cover.

A. Terminal box cover

2. For vented model installations only:

Remove either top or rear rectangular vent knockout. Install

vent connector/damper using the 2 - #8B sheet metal screws

provided.

3. Depending on your installation, remove either back or top

wiring hole knockout.

A. Wiring hole knockouts

B. Vent knockouts

C. #8B sheet metal screws

NOTE: If the wall cap is directly behind the vent connector/

damper, the damper in the connector and wall cap must not

interfere with each other. Remove the vent connector damper

if it interferes.

Cabinet

cutouts

*From wall, not

cabinet frame

4. Lift the range hood up under cabinet and determine final

location by centering beneath cabinet. Mark on the underside

of cabinet the location of the 4 keyhole mounting slots on the

range hood. Set range hood aside on a covered surface.

A. Keyhole slot

5. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.

A. Drill pilot hole.

6. Install the 4 - #10 x ⁵⁄₈" mounting screws in pilot holes. Leave

about ¹⁄₄" (6.4 cm) space between screw heads and cabinet

to slide range hood into place.

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

7. For Direct Wire Installations:

Install a UL listed or CSA approved strain relief.

A. UL listed or CSA approved strain relief

Pull about 12" (30 cm) of wire through wall or cabinet and

into opening.

For Power Supply Installations:

Follow instructions included with power supply cord kit

marked for range hoods.

¹⁄₄"

(6.4 mm)