Whirlpool AKR 555/1/IX 매뉴얼 - 페이지 5
{카테고리_이름} Whirlpool AKR 555/1/IX에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AKR 555/1/IX 11 페이지.
페이지 인쇄
MATERIAL SUPPLIED
Remove all the components from the packets. Check that all the components are included.
• Hood assembled with motor, lamps and grease filters installed.
• Flues (2 parts)
• Instructions for assembly and use
• 1 assembly template
• 1 Flue support bracket
• 1 deflector
• 1 Multiconnector
• 1 Decorative casing (flat or curved, depending on model)
• 4 Screws Ø 3.2x8
• 5 Wall plugs Ø 8mm
• 5 Screws Ø 5x45
• 1 Washer
• 2 Screws M6x23
• 2 Bushings
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS
The hood is designed for installation and use in "Extractor version" or in "Filter version".
Note: The model with electric shutter can only be used in "Extractor version" and the exhaust pipe must be connected to a peripheral extraction unit.
Extractor Version
Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood exhaust pipe connector.
Depending on the exhaust pipe purchased, provide for suitable fixing to the exhaust pipe connector.
IMPORTANT: If already installed, remove the carbon filter/s.
Filter Version
Air is filtered through the carbon filter/s and recycled into the surrounding environment.
IMPORTANT: check that air recirculation is facilitated.
If the hood does not have a carbon filter/s, order one/them and fit it/them before use.
Install the hood away from very dirty locations, windows, doors and sources of heat.
The hood comes supplied with all the materials required for installation on most walls/ceilings. However, a qualified technician is needed to make sure that the
plugs are suitable for your ceiling.
INSTALLATION DIMENSIONS
Adjacent wall units
65 cm (gas or combi cookers)
50 cm (electric cookers)
Adjacent wall units
600 mm min (1)
900 mm min (1)
centre line
cooktop surface
GB12
(1) depending on width of hood