Whirlpool AKR 948 설치 데이터시트 - 페이지 27
{카테고리_이름} Whirlpool AKR 948에 대한 설치 데이터시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AKR 948 28 페이지.
페이지 인쇄
31833160.fm Page 27 Friday, April 1, 2005 6:48 PM
AKR 631-666-812-966
AKR 943-948-952-995-996
Analogue control panel
Light
: move the switch to the right or press the button to switch on.
Extraction speed
: Move the switch to the right or press the next button to increase extraction speed
(or open the electric shutter
Digital control panel with sensors
The hood is fitted with a series of sensors which enable it to operate in 2 modes: Automatic mode and Manual
mode.
Automatic mode: the hood switches on automatically, depending on the ambient temperature (and heat) and
variations in this detected by the hood's sensors. See description of Button 3 function.
Manual mode: the hood is switched on by the user.
Description of Buttons
OFF/Stand by button:
1.
When the hood is OFF, all the controls are disabled (all LEDs are off).
When on stand-by, the hood is ready to operate in "Manual mode", LED C lights up.
Light ON/OFF button: always works, even when the hood is OFF.
2.
ON/OFF button "Automatic mode": press to activate this mode (LED C and E on) the hood switches
3.
on automatically, selecting a suitable extraction speed in accordance with the ambient temperature (and
heat) and any variations in this detected by the hood's sensors.
E switches off, LED C remains on (stand by). The hood will continue to run for a few minutes after you have finished
cooking but can be turned off by pressing buttons 1 or 3. The automatic function (LED on) stops a few minutes after
the motor has been switched off. The automatic function must be switched on every time you start cooking.
ON/OFF button for controlling intensive extraction speed in "Manual mode " (LED D switches on):
4.
when selected, it operates for 5 minutes, after which time the hood automatically reverts to the
previously selected extraction speed.
Buttons for controlling extraction speed 1 - 2 - 3 in "Manual mode ".
5.-6.
Description of LEDs
A. Carbon filter saturation led indicator: this led lights up to indicate that the carbon filter needs to be
cleaned or replaced.
Important: this indicator must be activated in order for the hood to work: to activate it, press buttons
4 and 5 at the same time - LED B lights up first, followed by LED A to indicate that the led indicator is
working.
B. Grease filter saturation led indicator: this led lights up to indicate that the grease filter needs to be cleaned.
C. "Stand by" led indicator.
D. Intensive speed led indicator.
E. "Automatic mode" led indicator.
F. Extraction speed 1 led indicator.
G. Extraction speed 2 led indicator.
H. Extraction speed 3 led indicator.
Reset filters indicator:
After cleaning or replacing the filters, with the hood on Stand by press Button 1 for more than 3 seconds.
Safety function: this function is activated ONLY with the hood on stand-by, in the event of any SUDDEN,
VIOLENT increase in the temperature detected by the sensors, upon which the hood switches to "Automatic
mode" and, if necessary, selects a suitable extraction speed.
5019 318 33160
PRODUCT SHEET
).
PL
CZ
SK
H RUS BG
Press again to revert to "Manual mode": LED
RO
GB