Whirlpool Cooker hoods 사용자 및 유지보수 매뉴얼 - 페이지 8
{카테고리_이름} Whirlpool Cooker hoods에 대한 사용자 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Cooker hoods 44 페이지. Cooker hoods
Whirlpool Cooker hoods에 대해서도 마찬가지입니다: 설치 및 사용 설명서 (7 페이지)
페이지 인쇄
INSTALLATION - ASSEMBLY INSTRUCTIONS
The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of
this manual.
IMPORTANT: The hood comes in filter version.
The carbon filter is supplied and must be fitted after installation (as shown in fig.12).
1. Mark a vertical centre line on the wall.
2. Place the drilling diagram against the wall (fix it with adhesive tape): the vertical centre line printed on the drilling diagram must match the centre line
drawn on the wall, and the bottom edge of the drilling diagram must match the bottom edge of the hood.
IMPORTANT: The bottom edge of the drilling diagram must have a min. distance of 50 cm (for electric hobs) or 65 cm (for gas hobs).
3. Drill the 3 holes as shown on the drawing.
4. Remove the drilling diagram from the wall, insert the 2 plugs and the 2 screws in the wall, making sure they protrude about 5 mm; insert the third plug in
the bottom hole.
5. Fit the plastic grille on the hood air outlet hole
6. Hook the hood on the fixing screws through the special rear perforation.
7. Remove the grease filters.
8. Insert the washer and safety screw in the bottom hole.
9. Secure the hood to the wall by tightening down the fixing screws.
10. Fit the power cable in it special place.
11. Secure the cable to the cable clamp.
IMPORTANT: This operation is compulsory. It will prevent accidental disconnection of the power cable.
Carry out the connection to the household electrical system.
12. Fit the carbon filters over the motor covering. Turn the filters to secure them to the middle pins.
13. Refit the grease filters.
Check hood operation, referring to the section giving a description of the hood and its use.
GB6