Whirlpool GXU7130DXQ1 사용 및 관리 매뉴얼 - 페이지 11

{카테고리_이름} Whirlpool GXU7130DXQ1에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool GXU7130DXQ1 28 페이지. 30" range hood

페이지 인쇄

RANGEHOOD USE

The range hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the hood

before cooking and allow it to operate several minutes after the

cooking is complete to clear all smoke and odors from the

kitchen.

The hood controls are located on the front panel on the right side

of the range hood.

A. Fluorescent

lamp housing

B. Grease filter handle

C. Blower and light controls

D. Grease filter

©©00

A. On/Off light button

B. Blower Off and speed minimum button

C. Blower speed medium button

D. Blower speed maximum button

Operating

the light

The On/Off light button controls the light. Press once for On and

again for Off.

Operating

the blower

The BLOWER SPEED buttons turn the blower on and control the

blower speed and sound level for quiet operation. The speed can

be changed anytime during fan operation by pressing the desired

blower speed button.

Press the BLOWER OFF button a second time to turn the blower

off.

Exterior Surfaces:

IMPORTANT:

Do not use soap-filled scouring pads, abrasive

cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths

or paper towels.

To avoid damage to the stainless steel, do not use cleaners that

contain chlorine.

Cleaning

Method:

•

Rub in direction of grain to avoid scratching

or damaging the

surface.

•

Stainless Steel Cleaner and Polish Part Number 31462A (not

included): See "Assistance

or Service" section to order.

•

Liquid detergent or all-purpose

cleaner:

Rinse with clean water and dry with soft, lint-free cloth.

•

Glass cleaner to remove fingerprints.

Metal Grease Filter

Remove each filter by pulling the spring release handle and

then pulling down the filter.

...................

A. Spring releasehandle

2. Wash metal filters as needed in dishwasher or hot detergent

solution.

3. Reinstall the filter by making sure the spring release handles

are toward the front. Insert aluminum filter into upper track.

4. Push in spring release handle.

5. Push up on metal filter and release handle to latch into place.

6. Repeat steps 1-5 for the other filter.

Replacing

a Fluorescent

Lamp

Turn off the range hood and allow the fluorescent

lamp to cool.

1. Disconnect

power.

2. Remove the screw from the lens cover and remove the cover.

RANGEHOODCARE

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace grease filters

before operating hood.

A. Screw

B. Lens cover

C. Fluorescent

lamp

3. Remove the light from the socket and replace with a 120 volt,

13-watt (maximum), 50 ° fluorescent

light for GX24 base.

4. Replace the lens cover and screw. Tighten the screw.

5. Reconnect power.

If new light does not operate, make sure the lamp is inserted

correctly before calling service.