Whirlpool GZ5730XR Series 설치 지침 및 사용 및 관리 설명서 - 페이지 6
{카테고리_이름} Whirlpool GZ5730XR Series에 대한 설치 지침 및 사용 및 관리 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool GZ5730XR Series 24 페이지. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood
Whirlpool GZ5730XR Series에 대해서도 마찬가지입니다: 치수 (1 페이지), 설치 지침 및 사용 및 관리 설명서 (24 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (24 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (24 페이지)
페이지 인쇄
Prepare Location
1. If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to upper
cabinet or rear wall. Slide cardboard or hardboard under
range before moving range across floor to prevent damaging
floor covering. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage
or dirt.
2. Determine which venting method (roof or wall venting or
non-venting) you need to use. This range hood is shipped for
non-vented installation.
A
centerline
cabinet
bottom
¹⁄₈" (3.0 mm)
wall
pilot holes
Hood size
30" (76.2 cm)
36" (91.4 cm)
3. Drill four ¹⁄₈" (3.0 mm) pilot holes for hood mounting screws. If
cabinet has recessed bottom, add wood shim strips on each
side.
4. From the following diagrams, select the diagram for your
installation.
Vented installations: Cut the vent system and electrical wiring
access holes as required.
Non-vented installations: Drill only the 1¹⁄₄" (3.2 cm) dia. wiring
access hole required.
If wiring through the top, use location shown in vertical
vent systems.
If wiring through the back, use location shown in
horizontal vent system.
3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular vertical vent system
5¹⁄₄"
(13.3 cm)
centerline
5"
1¹⁄₄"
(3.2 cm)
(12.7 cm)
6
INSTALLATION INSTRUCTIONS
10¹⁄₂"
A
(26.7 cm)
wood shim strips
(recessed cabinet
bottoms only)
1¹⁄₂"
(3.8 cm)
A
¹⁵⁄₁₆
13
" (35.4 cm)
¹⁵⁄₁₆
16
" (43.0 cm)
7¹⁄₂"
(19.1 cm)
1¹⁄₄" (3.2 cm)
wall
2"
dia. hole
(5.1 cm)
7" (17.8 cm) round vertical vent system
centerline
8" (20.3 cm)
dia. hole
5"
wall
(12.7 cm)
3¹⁄₄" x 10" (8.3 x 25.4 cm) horizontal vent system
centerline
cabinet front
¹⁄₈"
(3.2 mm)
3³⁄₄"
(9.5 cm)
5¹⁄₄"
(13.3 cm)
Prepare the Hood
WARNING
Excessive Weight Hazard
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
1. Set the hood on a protective covering such as cardboard or a
large towel. Remove the 7" (17.8 cm) round vent plate from
top of hood. Set vent plate and mounting screws aside.
A
A. 7" (17.8 cm) round vent plate
7¹⁄₂"
(19.1 cm)
1¹⁄₄" (3.2 cm)
2"
dia. hole
(5.1 cm)
1¹⁄₄" (3.2 cm)
dia. hole
³⁄₄"
(19 mm)
7¹⁄₂" (19.1 cm)