Whirlpool GZ5730XRS1 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 7
{카테고리_이름} Whirlpool GZ5730XRS1에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool GZ5730XRS1 24 페이지. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood
Whirlpool GZ5730XRS1에 대해서도 마찬가지입니다: 부품 설명서 (1 페이지)
페이지 인쇄
2,
top of hood. Set vent plate and mounting screws aside,
Remove tape holding standard filters in place. Remove both
filters. Insert flat blade screwdriver into slots in filters. Push
A
3,
,
B
A. Filterslots
B. Flatbladescrewdriver
each filter toward back of hood, lift out and set aside,
Remove damper/vent
connector from inside the hood. Set
4,
js
_
A
_
IJ
A, Damper/vent c onnector
connector, mounting screws and parts bag aside,
Remove wiring cover from inside the hood. Set cover and
5,
A. Hiring cover
mounting screw aside,
Depending on your installation, remove either top or back
wiring knockout and install a 1/2"UL- or CSA-listed strain
A. Strainrelief
relief,
For r_or_=vented
installations
Go to "Make ElectricaI Connection"
section,
For vented
installations
1, Remove the five screws holding the light panel in place and
set them aside.
2, Disconnect the light assembly wiring connector.
Make sure not to disconnect any wires.
3, Remove the light panel and set aside.
\
A \
5,
6,
7,
8,
A. Light panel
Remove
the air chute
held in place with one screw.
J
A, Air chute
Remove baffle from air chute.
A
A, Baffle
Rotate baffle and reinsert it back into the air chute so that the
baffle tabs fit all the way into the slots in the air baffle.This will
close off the air flow through the non-vented slots on top of
the hood.
B
A. Tab slots
B. Tabs
Replace air chute.
Connect light assembiy wiring connector and replace light
panel.
NOT_:: Make sure not to trap wires between the support fin
and light panel.