Whirlpool GZ5730XRT1 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 6
{카테고리_이름} Whirlpool GZ5730XRT1에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool GZ5730XRT1 24 페이지. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood
Whirlpool GZ5730XRT1에 대해서도 마찬가지입니다: 부품 설명서 (1 페이지)
페이지 인쇄
iNSTALLATiON iNSTRUCTiONS
1. If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to upper
cabinet or rear wall. Slide cardboard or hardboard under
range before moving range across floor to prevent damaging
floor covering. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage
or dirt.
2. Determine which venting method (roof or wall venting or
non-venting) you need to use. This range hood is shipped for
non-vented installation.
7" {17,8 cm) round
vertica_
vent
system
wall
5"
1 V4"(3.2 cm)
2"
(122 cm)
dia. hole
(5_1 cm)
wall
W' (3.0 ram)
1 F,"
pilot holes
(3.8 cm)
Hood size
A
30" (76,2 cm)
13_% '' (35,4 cm)
36" (91,4 cm)
16_5A6 '' (43,0 cm)
wood shim strips
(recessedcabinet
bottoms only)
3V4" x 10" {8,3 x 25,4 cm} horizonta_
vent
system
centerline
"",,q
1¼" (3,2 cm)
3¾"
(9_8 cm) (3.2ram) 511/_,,__7,/,,
' (19(19c2)m)
(13.3 cm)
3,
4,
Drill four W' (3.0 mm) pilot holes for hood mounting screws. If
cabinet has recessed bottom, add wood shim strips on each
side.
From the following diagrams, select the diagram for your
installation.
Vented installations: Cut the vent system and electricN wiring
access holes as required.
Non-vented installations: Drill only the 1_/_"(3.2 cm) dia. wiring
access hole required.
[]
If wiring through the top, use location shown in vertical
vent systems.
[]
If wiring through the back, use location shown in
3%" x t0"
{8,3 x 25,4 era) rectangular
vertica_
vent
system
5w'
horizontal vent system.
Set the hood on a protective covering such as cardboard or a
large towel. Remove the 7" (17.8 cm) round vent plate from
5"
1W'
wall
1V4"(3.2 cm)
2"
(12.7cm)
(3,2 cm)
dia, hole
(5,1 cm)
A. 7" (17.8 cm) round vent plate