FirePro FP-40T 설치 매뉴얼 - 페이지 2

{카테고리_이름} FirePro FP-40T에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FirePro FP-40T 19 페이지. Cylindrical aerosol units

General Installation Guide Line about the FirePro Aerosol Generators

FP-20SE/T/TH, FP-40S/T, FP-80S/T,FP-100S, FP-200S,FP-500S.

FP-20SE/T/TH:

Step 1: Take the "Bracket" and place it on the aerosol generator.

Step 2: Align "Bracket" holes with surface material holes.

Step 3: Select type of screws suitable to the surface material to be fixed (these screws are not

supplied with the kit).

Step 4: Pass the screws through the aligned holes and fix them on the surface material.

Step 5: The aerosol generator is ready for cable connections.

FP-40S/T, FP-80S/T:

Step 1: Take the "Bracket part 1" and place it on top of the aerosol generator.

Step 2: Take the "Bracket part 2" and place it under the aerosol generator.

Step 3: Align "Bracket part 1" holes with "Bracket part 2" holes.

Step 4: Select type of screws suitable to the surface material to be fixed (these screws are not

supplied with the kit).

Step 5: Pass the screws through the aligned holes and fix them on the surface material.

Step 6: The aerosol generator is ready for cable connections.

FP-100S/200S:

Step 1: Pass through the Aerosol Generator the Ring Bracket.

Step 2: Take ( L ) bracket and place it inside the ( Ring ) bracket.

Step 3: Align ( L ) bracket holes to the ( Ring ) bracket holes.

Step 4: Pass the screws through the aligned holes and tide them with the spanner key 11,13 to the

nuts. Use screw size "M8" for the longer hole and screw size "M6" for the smaller hole.

Step 5: Select type of screws suitable to the surface material to be fixed (these screws are not

supplied with the kit).

Step 6: Pass the selected screws through the ( L ) bracket holes and fix them on the surface material.

Step 7: The aerosol generator is ready for cable connections.

FP-500S:

Step 1: Pass through the Aerosol Generator the 2 Ring Brackets.

Step 2: Take each ( L ) bracket and place it inside the ( Ring ) bracket.

Step 3: Align each ( L ) bracket holes to the ( Ring ) bracket holes.

Step 4: Pass the screws through the aligned holes and tide them with the spanner key 11,13 to the

nuts. Use screw size "M8" for the longer hole and screw size "M6" for the smaller hole.

Step 5: Select type of screws suitable to the surface material to be fixed (these screws are not

supplied with the kit).

Step 6: Pass the selected screws through the ( L ) bracket holes and fix them on the surface material.

Step 7: The aerosol generator is ready for cable connections.