Whirlpool HE568 사용, 관리 및 설치 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool HE568에 대한 사용, 관리 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool HE568 40 페이지.

1. Find a suitable installation position of hood which

should be next to a window and can be cut to let

the exhaust duct pass through.

2. If the exhaust duct has to pass through the wall,

particular attention must be paid to the structure of

the wall as steel reinforcement may be embedded.

3. Mark the location of exhaust outlet hole, then cut/

drill the hole with care.

4. Fix the position of hood and mark the position of

the two hanging hooks.

5. Drive 2 steel nails into the selected wall with 3 mm

(maximum)space leave behind for hanging the hood.

6. Adjust the hanging hooks on both sides of the hood

and hang the hood on the steel nails, and then

adjust the hood from side to side and from front

and back to a horizontal position.

7. Follow the instruction print on the enclosed exhaust

duct adapter and connect the exhaust duct adapter

to the hood and window/wall. 5-inch or 6-inch duct

can be used.

8. Fasten the hanging bracket to the wall by screws

from the fixed holes to avoid of being hanged up

by accident.

9. To ensure drainage performance, hood shall be

installed with slope (2 - 4 mm) as shown in figure.

And rubber cushion(at rear housing) MUST

NOT be removed, otherwise appliance will be

operated unstable/noisy and water leakage.

ROCEDURE

Plywood

Exhaust

duct

3mm(maximum limit)

screw

Wall

Level

Tilted

Keeps the hood in level to avoid

the oil leaking from oil cup.

Drill a hole for the air tube Drive 2

steel nails in, on the upper corner

of the both side of the hood.

Adjust the hang hood and

prepare to install

2-4mm

√