Whirlpool RH3730XLS3 설치 지침 및 사용 및 관리 설명서 - 페이지 9

{카테고리_이름} Whirlpool RH3730XLS3에 대한 설치 지침 및 사용 및 관리 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool RH3730XLS3 24 페이지. 30" (76.2 cm) and 36" (91.4 cm) range hood
Whirlpool RH3730XLS3에 대해서도 마찬가지입니다: 부품 목록 (1 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (24 페이지)

페이지 인쇄

1. Remove terminal box cover. Depending on your installation,

remove either back or top wiring knockout.

A. Terminal box cover

2. Remove the rectangular and round vent connectors from

hood. Set the connectors and screws aside for use if

connecting to a rectangular vent system.

3. For vented installations:

Check that the louver cover is installed in front of hood.

Remove either top or rear rectangular vent knockout. If

using round vent, remove both top rectangular and

semicircular knockouts.

If using rectangular vent, attach rectangular damper/vent

connectors.

Reinstall round vent connector.

NOTE: If the wall cap is directly behind the vent connector,

the dampers in the connector and wall cap must not interfere

with each other. Remove the vent connector damper if they

interfere.

For non-vented installations:

Remove louver cover from front of hood.

4. Lift the range hood up under cabinet and determine final

location by centering beneath cabinet. Mark on the underside

of cabinet the location of the 4 keyhole mounting slots on the

range hood. Set range hood aside on a covered surface.

A. Keyhole slot

Install Range Hood

5. Use

" (3 mm) drill bit and drill 4 pilot holes as shown.

A. Drill pilot hole

6. Install the 4 - #10 x

" mounting screws in pilot holes. Leave

about

" (6.4 cm) space between screw heads and cabinet

to slide range hood into place.

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

7. For Direct Wire Installations:

Install a UL listed or CSA approved strain relief.

A. UL listed or CSA approved strain relief

Pull about 12" (30.0 cm) of wire through wall or cabinet

and into opening.

For Power Supply Installations:

Follow instructions included with power supply cord kit

marked for range hoods.

8. Using 2 people, lift range hood into final position, feeding

electrical wire through wiring opening. Position the range

hood so that the large end of the keyhole slots are over the

screws. Then push the hood toward the wall so that the

screws are in the neck of the slots. Tighten mounting screws

to cabinet, making sure mounting screws are in narrow neck

of slots.

9. Check that damper, if used, rotates up and down freely.

10. For Vented Installations Only:

Connect ventwork to hood. Seal joints with clamps to make

secure and airtight.

(6.4 mm)