3Com 4200G Series 설치 매뉴얼 - 페이지 3

{카테고리_이름} 3Com 4200G Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 4200G Series 4 페이지. 3com switch 4200g gigabit family
3Com 4200G Series에 대해서도 마찬가지입니다: 제품 설명서 (13 페이지), 제품 설명서 (15 페이지), 제품 설명서 (15 페이지), 데이터시트 (8 페이지), 데이터시트 (8 페이지)

페이지 인쇄

2. XENPAK Optical Module

2.1 Appearance and front panel

Figure 4 Appearance of a XENPAK optical module

Figure 5 Front panel of a XENPAK optical module

2.2 Installation

Step 1: Put on an ESD-preventive wrist strap and verify it is properly

grounded. Then remove the XENPAK optical module from the package.

Step 2: Loosen the two mounting screws on the small cover plate in the

middle on the filler panel with a screwdriver and remove the small cover

plate.

Note: When installing a XENPAK optical module, you do not need to

remove the entire filler panel. Just remove the small cover

plate in the middle on the filler panel.

Step 3: Hold the fastening screws on the front panel of the XENPAK

optical module, and gently push the XENPAK optical module in along the

slot guide rail until the XENPAK optical module is in close contact with the

switch.

Step 4: Tighten the fastening screws on the XENPAK optical module with

a screwdriver to fix the XENPAK optical module on the filler panel.