Whirlpool UXL5430BSS1 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Whirlpool UXL5430BSS1에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool UXL5430BSS1 16 페이지.

페이지 인쇄

Transfer measurement A to the cabinet back wall. Measure

from the underside of the cabinet. Mark the cutout as shown.

Use a saber saw or keyhole saw to cut a round opening

through the back of the cabinet and the exterior wall for the

vent.

Go to Step 3.

A. Measurement A

B. Centerline

C. 6¼" (15.9 cm) round cutout

Non-Vented (recirculating) Installation Through the

Soffit/Cabinet

Measure and mark the centerline of the cabinet to the soffit

above.

Measure from the bottom of the cabinet to the centerline of

the where the vent will come through the soffit. Mark the

location and use a saber saw or keyhole saw to cut a 5¾"

(14.6 cm) hole for the vent cover.

A. Vent cover

B. Centerline

Measure and mark the centerline location for the cutout in the

cabinet top. Use a saber saw or keyhole saw to cut an

opening for the vent.

A. Cutout

B. *See chart below.

³⁄₄

C. 7

" (19.7 cm) centerline to cabinet front

D. Centerline

Cabinet Height

Hole Shape and Size

12" (30.5 cm)

A 6¼" deep x 8" wide (15.9 cm x 20.3 cm)

rectangular opening in the cabinet top is

required for damper transition clearance.

15" (38.1 cm)

A 6¼" (15.9 cm) diameter round opening is

cabinet or soffit

required.

installation

18" (45.7 cm) or

A 5¾" (14.6 cm) diameter round opening is

24" (61.0 cm)

required.

For non-vented (recirculating) installations only, the range

hood can be vented indoors through the top of the cabinet.

For non-vented (recirculating) installations, charcoal filters are

necessary. See the "Range Hood Care" section for

instructions on installing charcoal filters.

The Recirculation Kit Part Number W10490330 must be used.