Whirlpool UXT2030AD 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool UXT2030AD에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool UXT2030AD 28 페이지. 30" (76.2 cm) range hood
Whirlpool UXT2030AD에 대해서도 마찬가지입니다: 설치 지침 및 사용 및 관리 매뉴얼 (28 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (32 페이지)

페이지 인쇄

NOTES:

Depending on your model, determine which venting

■

method to use: roof or wall.

It is recommended that the vent system be installed before

■

the range hood is installed. Go to "Venting System" in the

"Installation Requirements" section if you need assistance.

Before making cutouts, make sure there is proper clearance

■

within the ceiling or wall for the vent system.

1. Disconnect power

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

2. Mark Hole Locations

Align the exterior edge of the mounting brackets

with the exterior edges of the upper cabinet.

IMPORTANT: The brackets should touch the upper cabinet.

With a pencil, mark the upper holes on the brackets.

INSTALLATION INSTRUCTIONS

3. Install Brackets

Using a #2 Phillips screwdriver, install the drywall anchors.

■

Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws,

■

install the mounting brackets using the upper holes.

NOTE: For installations to a surface other than drywall,

it is recommended that a qualified contractor determine

the anchoring method.

4. Prepare Range Hood

Set the range hood on its back on a covered surface.

■

Using a #2 Phillips screwdriver, remove the 7"

■

(17.8 cm) round vent mounting plate attached

with 3.5 x 9.5 mm screws.

Using a #2 Phillips screwdriver, remove the electrical

■

box cover.

Using a flat-blade screwdriver, remove the appropriate

■

power supply knockout.