Whirlpool UXT2030ADB0 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool UXT2030ADB0에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool UXT2030ADB0 28 페이지. 30" (76.2 cm) range hood

5. Mark Hole Locations

Lift the range hood into place and insert the mounting bracket

tabs through the slots in the back of the range hood.

6. Mark and Cut Vent Opening

7" (17.8 cm) Round Vent System

•

Using the 7" (17.8 cm) round vent mounting plate, draw the

vent opening outline on the underside of the cabinet:

Place the vent mounting plate on the bottom of the

cabinet. Position the edge of the plate with the widest

distance (A) between the hole and edge of the mounting

plate against the wall. Position the side edges of the

mounting plate between the dots marked previously.

IMPORTANT: The widest edge (A) of the vent mounting

plate must be positioned against the wall.

Trace the 7" (17.8 cm) vent opening (solid line) on the

cabinet bottom.

•

Using a jigsaw or keyhole saw, cut the vent opening 1"

(2.5 cm) larger than the 7" (17.8 cm) hole traced (dashed line).

7. Drill Electrical

Opening

Hold the range hood firmly in place with one hand and bend each

mounting tab (A) upward approximately 90 °.

Mark the hole at the power supply knockout (B).

Mark the 4 vent hole locations (C) on the top of the range hood.

OPTIONAL: Mark the hole in each mounting tab.

Remove the range hood and set it aside.

Using a 11/4"(3 cm) drill bit, drill the hole in the dot marked

previously at the electrical strain relief.

OPTIONAL: Using a 1/8"(3 mm) drill bit, drill pilot holes for the

dots marked previously at each mounting tab at an approximate

45 ° angle in an upward direction.