Whirlpool UXT4030AD 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 8
{카테고리_이름} Whirlpool UXT4030AD에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool UXT4030AD 24 페이지. 30" and 36" (76.2 and 91.4 cm) range hood
Whirlpool UXT4030AD에 대해서도 마찬가지입니다: 설치 지침 및 사용 및 관리 매뉴얼 (28 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (24 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (24 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (24 페이지)
페이지 인쇄
8. Mount Range Hood
Lift the range hood into place, positioning the rear slots
■
over the mounting brackets.
Using a Phillips screwdriver, push on the screws that
■
are started into the top mounting tabs and bend the
tabs against the cabinet side walls. Attach the screws
to the cabinet side walls.
IMPORTANT: Do not overtighten the screws.
For direct wire installations, run the home power supply
■
cable according to the National Electric Code or CSA
standards and local codes and ordinances. There must
be enough wiring from the fused disconnect (or circuit
breaker) box to make the connection in the range hood
electrical terminal box.
Tighten the strain relief screws.
■
NOTE: Do not reconnect power until the installation
is complete.
OPTIONAL: If you prefer, bend the rear tabs against
the rear of the range hood and attach to the wall using
#8-18 x
/
" (4.2 x 16 mm) truss-head screws.
5
8
9. Make Electrical Connection
8
A
B
C
Option 1 - Direct Wire Installations
Use a UL Listed/CSA Approved wire connector
■
and connect the 3 white wires (A) together.
Use a UL Listed/CSA Approved wire connector
■
and connect the 2 black wires (B) together.
WARNING
Fire Hazard
Electrically ground the blower.
Use copper wire.
Connect ground wire to green ground screw in
terminal box.
Failure to do so can result in death, fire, or
electrical shock.
Connect the green (or bare) ground wire (C) from the
■
power supply to the green ground screw in the electrical
box and tighten the screw securely.
Reinstall the electrical box cover.
Reconnect power.
Option 2 - Power Cord Kit Installations
For optional power cord kit installations, follow the instructions
supplied with the power cord kit. See the "Assistance or
Service" section for information on ordering.
NOTE: Use only with range hood cord connection kits that
have been investigated and found acceptable for use with
this model range hood.
10. Complete the Installation
Install a 120V, 75W maximum, light bulb with
■
E26 base. See "Replacing the Light Bulb" in
the "Range Hood Care" section.
If removed previously, replace the filter. See "Charcoal
■
Grease Filter" in the "Range Hood Care" section.
Check the operation of the range hood fan and light.
■
See the "Range Hood Use" section.
If the range hood does not operate, check to see whether
a circuit breaker has tripped or a household fuse has blown.
Disconnect the power and check the wiring connections.
NOTE: To get the most efficient use from your new
range hood, read the "Range Hood Use" section.