Whirlpool UXT4130AD 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 11

{카테고리_이름} Whirlpool UXT4130AD에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool UXT4130AD 28 페이지. 30" and 36" (76.2 and 91.4 cm) range hood
Whirlpool UXT4130AD에 대해서도 마찬가지입니다: 설치 지침 및 사용 및 관리 매뉴얼 (28 페이지)

페이지 인쇄

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace the grease

filter before operating hood.

Exterior Surfaces

IMPORTANT: Do not use soap-filled scouring pads,

abrasive cleaners, cooktop polishing creme, steel wool,

gritty washcloths, or paper towels.

To avoid damage to the stainless steel, do not use cleaners

that contain chlorine.

Cleaning Method:

Liquid detergent or all-purpose cleaner:

■

Rinse with clean water and dry with a soft, lint-free cloth.

Glass cleaner to remove fingerprints.

■

For stainless steel models, rub in the direction of the

■

grain to avoid scratching or damaging the surface.

For stainless steel models, use Stainless Steel Cleaner

■

and Polish, Part Number 31462A (not included):

See the "Assistance or Service" section to order.

Metal or Charcoal Grease Filter

To Clean the Filter:

1. Remove the screw from the grease filter retainer.

2. Turn the grease filter retainer to release the filter.

A. Filter retainer

3. For vented installations: Wash the metal filter as needed

in a dishwasher or hot detergent solution.

For non-vented (recirculating) installations: Replace

the metal filter with a charcoal filter. The charcoal filter is

not washable. It should last up to 6 months with normal

use. For information on ordering, see the "Assistance

or Service" section. Dispose of old charcoal filter.

To Replace the Filter:

1. To reinstall the filter, place the back edge of the filter into the

channel at the rear of the hood. Push the filter into place and

turn the filter retainer to secure the filter to the range hood.

2. Replace the screw in the grease filter retainer.

RANGE HOOD CARE

Cleaning

Replacing the Light Bulb

Turn off the range hood and allow the light bulb to cool.

1. Disconnect power.

2. Squeeze the plastic lens cover and remove it from the hood.

3. Screw a 120V, 75W maximum, light bulb with

4. Replace the lens cover by squeezing the cover

5. Reconnect power.

If the new light does not operate, make sure the light bulb

is inserted correctly before calling service.

E26 base into the socket.

and inserting the tabs into the slots.