Whirlpool UXT4136ADW0 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool UXT4136ADW0에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool UXT4136ADW0 28 페이지. 30" (76.2 cm) and 36" (91.4 cm) range hood

페이지 인쇄

5. Mark Hole Locations

Lift the range hood into place and insert the mounting bracket

tabs through the slots in the back of the range hood.

Hold the range hood firmly in place with one hand and bend each

mounting tab (A) upward approximately 90 °.

Mark the hole at the power supply knockout (B).

OPTIONAL: Mark the hole in each mounting tab.

For a non-vented (recirculating) installation: Go to Step 7.

For a top vented installation: Mark the 4 vent hole locations (C)

on the top of the range hood.

For a rear vented installation:

Mark the 4 vent hole locations (D)

on the rear of the range hood.

Remove the range hood and set it aside.

6. Mark and Cut Vent Opening

31/4 '' x 10" (8.3 x 25.4 cm) Rectangular

Vent System

•

Using a 1/2"(13 mm) drill bit, drill a hole in each of the dots

marked previously on either the wall or upper cabinet. Using

the outside edges of the holes, mark the vent opening.

•

Using a jigsaw or keyhole saw, cut the vent opening.

7. Drill Electrical

Opening

Using a 11/4"(3 cm) drill bit, drill the hole in the dot marked

previously at the electrical strain relief.

OPTIONAL: Using a 1/8"(3 mm) drill bit, drill pilot holes for the

dots marked previously at each mounting tab at an approximate

45 ° angle in an upward direction.