Whirlpool UXT4230ADS0 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 8
{카테고리_이름} Whirlpool UXT4230ADS0에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool UXT4230ADS0 28 페이지. 30" (76.2 cm) and 36" (91.4 cm) range hood
페이지 인쇄
7. Drill Electrical
Opening
9. Attach
Vent Damper
or Transition
31/4 '' X 10" (8.3 X 25.4 cm) Rectangular
Vent Damper
Using a 11/4"(3 cm) drill bit, drill the hole in the dot marked
previously at the electrical strain relief.
OPTIONAL: Using a 1/8"(3 mm) drill bit, drill pilot holes for the
dots marked previously at each mounting tab at an approximate
45 ° angle in an upward direction.
8. Prepare
Range
Hood
Vents and
Mounting
Tabs
•
Install Strain Relief
Install a UL Listed/CSA Approved 1/2"(13 mm) strain relief (A).
•
Mounting
Tabs
Start a #8-18 x %" (4.2 x 16 ram) truss-head screw into the
mounting tab (F) on each side of the range hood as shown in
the inset. Insert the screws approximately
2 turns into the
mounting tab holes.
•
Non-vent
(Recirculating)
Installations
Remove the (2) T10 ®Torx ®screws and remove the top, front
rectangular vent cover (E). Go to Step 12.
•
31/4 '' x 10" (8.3 x 25.4 cm) Rectangular
Vent Installations
For top vent installations,
remove the top, rectangular vent
knockout (C).
OR
For wall vent installations, remove the rear rectangular vent
knockout (B).
•
7" (17.8 cm) Round Vent Installations
Remove both top knockouts (C and D).
Using (2) short Phillips head screws, install the 31/4"x 10" (8.3
x 25.4 cm) rectangular damper over the top or rear vent
knockout removed in Step 8.
NOTE: If the wall cap used has a damper and it interferes
with the rectangular damper, remove the rectangular damper
flap.
7" (17.8 cm) Round Vent Mounting Plate
B
Using (2) short Phillips head screws, install the 7" (17.8 cm)
round vent mounting plate over the vent knockouts removed
in Step 8. Position the wide flange (C) to the front.
NOTE: An optional 7" (17.8 cm) round damper (A), Part
Number W10355451, and a 7" (17.8 cm) round vent mounting
plate (B), Part Number W10388168, are available as
accessories.
For information on ordering, see the "Assistance
or Service" section.
If installing the optional round damper, position it over the
round vent mounting plate.
8