Whirlpool WVU17UC0JB 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 11

{카테고리_이름} Whirlpool WVU17UC0JB에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WVU17UC0JB 24 페이지. 30" 76.2 cm
Whirlpool WVU17UC0JB에 대해서도 마찬가지입니다: 설치 지침 및 사용 및 관리 매뉴얼 (24 페이지)

페이지 인쇄

Whirlpool WVU17UC0JB 설치 지침 및 사용 및 관리 매뉴얼

3. For vented installations: Grease filters should be cleaned

using warm water, dishwashing liquid, and a non abrasive

brush.

For non-vented (recirculating) installations: The charcoal

filter is not washable. For information on ordering, see the

"Assistance or Service" section.

NOTE: To reduce the risk of fire or shock when the hood

is used in recirculation mode, use only the conversion kit

models listed below:

Recirculating kit: W11371717

To Replace the Filter:

1. To reinstall the filter, place the back edge of the filter into the

channel at the rear of the hood. Push the filter into place and

turn the filter retainer to secure the filter to the range hood.

2. Replace the screw in the grease filter retainer.

SEL0157858A

WIRING DIAGRAM

Light Switch

Off - On

LED BULB

E26

Motor characterstics

Power Supply

120 VAC

60 Hz

Frequency

Current

1.2±10%A

Power absorption

73±10% W

Motor resistance (ohms)

White - Red

17.1±10% Ohms

White - Black

13.6±10% Ohms

For supply connection

use wires suitable for

at least 75° (167°F)

Replacing the LED Light Bulb

Turn off the range hood and allow the light bulb to cool.

1. Disconnect power.

2. Remove the grease filters from the hood.

3. Remove the fused light bulb from behind the lamp spacer.

4. Screw a 120 V, 9 W maximum, LED light bulb with E26 base

into the socket.

5. Replace the grease filters.

6. Reconnect power.

If the new light does not operate, make sure the light bulb is

inserted correctly before calling service.

Motor Switch

Low - Off - High

C25

For ADA compliance add these elements

Ground

Screw

Remote Switch

during the installation