Whirlpool WVU57UC6F 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 10

{카테고리_이름} Whirlpool WVU57UC6F에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WVU57UC6F 36 페이지. 30 inch (76.2 cm) and 36 inch (91.4 cm)
Whirlpool WVU57UC6F에 대해서도 마찬가지입니다: 설치 지침 및 사용 및 관리 매뉴얼 (36 페이지)

페이지 인쇄

Install Vent System

1. Install vent through the vent opening in upper cabinet or wall.

Complete venting system according to the selected venting

method. See the "Venting Requirements" section.

2. Use caulking to seal exterior wall or roof opening around

the cap.

Prepare Range Hood

Only for venting through the top/wall options:

1. Remove vent knockouts, depending on your installation

requirements.

A. Round vent knockout

B. Top rectangular vent knockout

C. Rear rectangular vent knockout

Round vent system installations - Remove top rectangular and

round vent knockouts.

Rectangular vent system installations - For roof installations,

remove the top rectangular vent knockout. For wall installations,

remove the rear rectangular vent knockout.

Non-vent (recirculating) installations - Do not remove any

knockouts.

2. Install 7" (17.8 cm) round vent mounting plate or 3¹⁄

(8.3 cm x 25.4 cm) vent damper, depending on your vent

system installation. Attach to range hood with 3.5 x 9.5 mm

screws provided and remove the tape from the damper flap.

NOTE: An optional 7" (17.8 cm) round damper is also

available as an accessory. For information on ordering,

see the "Accessories" section.

A. 7" (17.8 cm) round damper

(See the "Accessories" section)

B. 3.5 x 9.5 mm screws

C. 7" (17.8 cm) round vent mounting plate

D. Round vent knockout

E. Rectangular vent knockout

" x 10"

NOTE: The round vent damper may only be installed on the top

of the product.

A. Vertical air transition

B. 3.5 x 9.5 mm screws

C. Vent knockouts

D. Horizontal air transition

Only for recirculating options

For this venting method, it is neccesary to purchase a Charcoal

Filter Kit. See the "Accessories" section for ordering.

1. Remove each filter by pulling the spring-release handle and

then pulling down the filter.

2. Remove the venting method screw from the Vented option

with a T10 TORX

screwdriver and set aside.

A. Venting method screw