Whirlpool WVW75UC0DS0 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 8
{카테고리_이름} Whirlpool WVW75UC0DS0에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WVW75UC0DS0 28 페이지. 30" and 36" (76.2 and 91.4 cm) wall-mount canopy range hood
페이지 인쇄
1=
00_:_
Using 2 or more people, hang range hood on 2 mounting
screws through the mounting slots on back of hood.
C
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
2. Remove the grease filter. See "Range Hood Care" section.
3. Level the range hood and tighten upper mounting screws.
4. Install 2 - 5 x 45 mm lower mounting screws and tighten.
1=
Install transition on top of hood (if removed for shipping) with
2 - 3.5 x 9.5 mm sheet metal screws.
A
B
\
A. Vent transition
B. 3.5 x 9.5 mm screw
For vented installations
only:
1. Fit vent system over the exhaust outlet.
2. Seal connection with clamps.
3. Check that back draft dampers work properly.
For non-vented (recirculating) installation only:
1. Assemble the air deflector with the duct cover bracket using
4 - 4.2 x 8 mm screws.
2=
3=
4.
5.
6.
7=
8=
B
C
A.Assembly screws
B. Air deflector
C. Duct cover bracket
Measure from the bottom of the air deflector to the bottom of
the hood outlet.
/
...................................................
A
B
D .......................
i_ _
| ...............
A.Air deflector
D. Vent duct
B. Ventclamp
E. Exhaust outlet
C. X = length to cut vent duct
Cut the duct to the measured size (X).
Remove the air deflector.
Slide the duct onto the bottom of the air deflector.
Place the assembled air deflector and duct over the exhaust
outlet from the hood.
Reassemble the air deflector to the duct cover bracket with
the 4 assembly screws.
Seal connections
with vent clamps.
8