Clare Controls CM-BT10-TXRX100 사용자 설명서 - 페이지 9

{카테고리_이름} Clare Controls CM-BT10-TXRX100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Clare Controls CM-BT10-TXRX100 20 페이지. Clare controls cm-bt10-txrx100 hdbaset extender set 100m

페이지 인쇄

Figure 2: The Rx100 receiver

(1) ON

(2) LINK

(3) OUT

(4) POWER LED

(5) ETHERNET

(6) HDBT IN

(7) HDMI OUT

(8) IR IN

(9) IR OUT

(10) RS-232

(11) 24 VDC

HDBaseT Extender Set 100m User Guide

(1) (2) (3) (4)

Working status indicator of this device. When the receiver is on and

working properly, the green LED blinks.

HDBaseT link status indicator, green LED. It remains illuminated when

the device has a connection.

The LED remains illuminated when connected to a device that supports

HDCP and is working normally. The LED blinks when the device does

not support HDCP.

The red LED illuminates and stays on when power is connected.

Built-in Ethernet connectivity. Connect any of the Ethernet ports found

on the transmitter or receiver for Internet access and to feed your

IP-enabled devices. You can also connect to an existing LAN to

integrate all IP-enabled devices connected to the Extender Set. When

properly connected, the yellow LED indicators blink and the green

indicators remain illuminated.

Connects to the HDBaseT port on the receiver via a single Cat5e/Cat6

cable.

Connect to the HDMI display device.

Infrared signal input. Collects infrared signals to be sent via HDBaseT to

the transmitter (Tx) IR OUT.

Infrared signal input. Outputs infrared signals received from the

transmitter (Tx) via HDBaseT.

RS-232 connector. Supports bi-directional RS-232 communication.

Connects to the power supply.

(5)

(6)

(7) (8) (9) (10) (11)