Clare Controls CH-THSTAT-W 운영 매뉴얼 - 페이지 2

{카테고리_이름} Clare Controls CH-THSTAT-W에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clare Controls CH-THSTAT-W 15 페이지. Wi-fi thermostat
Clare Controls CH-THSTAT-W에 대해서도 마찬가지입니다: 설치 매뉴얼 (10 페이지)

페이지 인쇄

Setting the heating or cooling temperature setpoint

Setpoint change screen

Press "DONE" button to set the setpoint and exit back

to the main thermostat screen or wait for the screen to

automatically time out.

If the System Mode is OFF, pressing either the Up or Down buttons will take you

to the System Mode screen. You must first set an operating mode before you can

set or change the setpoint.

To change the Heat Setpoint you must be in the Heating mode, to change the Cool

Setpoint you must be in the Cooling mode. If you are in Auto mode, the mode of the

last system call will be the setpoint screen displayed. Press the Change Mode button

to toggle between Heat and Cool mode.

Setpoint Push: Note that you cannot lower the cooling setpoint below the heating

setpoint. The thermostat will "push" the heating setpoint lower if you try to lower the cooling

setpoint below the heating setpoint. It maintains a 3 degree separation between the

heating and cooling setpoint. The same is true for raising the heating setpoint above the

cooling setpoint. Again the thermostat will "push" the cooling setpoint up to maintain the 3

degree separation.

Doc ID 2014-05-223 • Rev 02

4:30

Sys Off

HEAT

AUTO

MODE

FAN

HEATING SETPOINT

Done

64H

82C

HOLD

Press the up or down arrow buttons to

set the desired temperature setpoint

COOL

Change Mode button

Press a button to

go to the setpoint

change screen

Raise Temperature

Lower Temperature

Pressing the up

or down buttons

will increment the

setpoint 1 degree.

Press and hold

the button to

ramp the setpoint.

Page 2