Caldera Vacanza Palatino 사전 배송 지침 - 페이지 11

{카테고리_이름} Caldera Vacanza Palatino에 대한 사전 배송 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Caldera Vacanza Palatino 16 페이지.

230 v

olt

nstallatIon

Your spa contains a control box designed to operate at 230V, 60Hz. Installation of a 30 or 50 amp dedicated circuit

is required. The control box must be hard wired directly to a subpanel protected by a Ground Fault Circuit Interrupter

(GFCI). The subpanel containing the GFCI breaker is included with the PALATINO, MARINO and VANTO spas.

IMPORTANT NOTE: All electrical connections to the control box must be accomplished by a qualified electrician in

accordance with the National Electrical Code and in accordance with any local electrical codes in effect at the time

and place of installation.

All electrical connections must be made in accordance with the wiring information contained in this manual and on

the back of the control box panel. A licensed electrician should install a four-wire electrical service (two line voltages,

one neutral, one ground) from the main electrical service panel to the subpanel.

The grounding conductor must be at least #8 AWG. Your electrician should mount the subpanel in the vicinity of the

spa but it should not be closer than five (5) feet from the spa water edge (NEC 680-38 to 41-A-3).

INSTALLATION NOTE: After the spa has been installed, your electrician can connect the conduit from the subpanel

to the spa's control box and then complete the wiring connections in the control box.

NOTE: Complete step-by-step Installation and Wiring Instructions for all models are included in the Owner's Manual

and with each subpanel, which can be obtained from your dealer.

WARNING: Removing or bypassing the GFCI breakers in the subpanel at any time will result in an unsafe spa and

will void the warranty.

POWER CONNECTION ACCESS FOR PALATINO,

MARINO, VANTO & TARINO

230V WIRING ACCESS

OPENINGS ON LEFT & RIGHT

HAND SIDE

CONTROL BOX

EQUIPMENT

COMPARTMENT DOOR

PUMP DOOR

Page 11