FireScapes 702 주택 소유자 설치 및 운영 매뉴얼 - 페이지 5
{카테고리_이름} FireScapes 702에 대한 주택 소유자 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FireScapes 702 5 페이지.
페이지 인쇄Upon completing the gas line connection, a small
amount of air will be in the lines. When first
lighting the burner, it will take a few seconds for the
lines to purge themselves of this air. Once the
purging is complete the burner will light and
operate as indicated in the instruction manual.
Subsequent lighting of the appliance will not
require such purging.
Lighting and Operating Instructions
Lighting and Operating Instructions
Lighting and Operating Instructions
Lighting and Operating Instructions
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: If you do not follow those instructions
exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A. The appliance must be lit manually. When
lighting follow these instructions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell
next to the floor because some gas is
heavier than air and will settle on the floor.
C. Use only your hand to turn the gas control
key. Never use tools. If the key will not
turn by hand do not try to repair it. Call a
qualified service technician. Applying force
or any attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the gas
control which has been under water.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance
• Do not touch any electric switch
• Do not use any phone in your building
• Immediately call you gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
Assembly and Installation
Lighting Instructions
Lighting Instructions
Lighting Instructions
Lighting Instructions
1. ST0P! Read the safety information above.
2. Remove the cover.
3. Insert the "TEE" handle in the valve.
4. Hold the log lighter towards the center of the
burner.
• For natural Gas unit, turn the "TEE"
handle slowly counterclockwise.
• For LP unit, turn the valve on the LP tank
counterclockwise all the way and then
turn the "TEE" handle on the valve slowly
counterclockwise.
5. If the burner does not light immediately turn
the gas valve to "OFF".
6. Wait at least five (5) minutes to clear out
any gas. Then smell for gas, including near
the floor. If you smell gas, STOP! Follow
the safety information above WHAT TO
DO IF YOU SMELL GAS. If you do not
smell gas, repeat steps.
To Turn Off Gas to Appliance
To Turn Off Gas to Appliance
To Turn Off Gas to Appliance
To Turn Off Gas to Appliance
1. Turn the "TEE" handle to the "OFF"
position fully clockwise at the unit, then turn
the valve on the LP tank to the "OFF"
position, fully clockwise. Remove "TEE"
handle.
2. Replace cover when until has completely
cooled.