Firesense 1902415 조립/관리 및 사용 지침 - 페이지 5

{카테고리_이름} Firesense 1902415에 대한 조립/관리 및 사용 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Firesense 1902415 17 페이지.

ASSEMBLY

PREPARATION

Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents

list and hardware contents as listed on page of this manual. If any part is missing or damaged, do not attempt to

assemble this product. Contact customer service for replacement parts.

ESTIMATED ASSEMBLY TIME: 60 minutes

Tools Required for Assembly (NOT included):

Note: This heater has an Electronic Ignition and will require installation of 1 – AAA battery. The battery should be installed

by unscrewing the RED IGNITER BUTTON – battery not included.

The Waterbox

Attach Wheel Assembly

Base, and insert 2 Small Bolts

Hardware Used: 2x Small Bolts

Attach the Post Supports

in the bottom of each Post Support with the hole on the

Base. Insert 1 Small Bolt

and into the Base and hand tighten. Repeat with the other 2

Post Supports and then tighten all bolts with the Wrench

Hardware Used: 3x Small Bolts

to Base

. Align holes to the

through the holes

to the Base

. Align the holes

through the hole in the support

Base

Waterbox Cap