Clarinet Systems EtherUSB EA104 사용자 설명서 - 페이지 7

{카테고리_이름} Clarinet Systems EtherUSB EA104에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarinet Systems EtherUSB EA104 15 페이지. Usb ethernet access point for pda
Clarinet Systems EtherUSB EA104에 대해서도 마찬가지입니다: 사양 (2 페이지), 사양 (2 페이지), 사용자 설명서 (11 페이지), 사용자 설명서 (19 페이지)

페이지 인쇄

2.2 Hardware Installation

1. Connect the Ethernet cable to the EA104 Ethernet uplink (WAN) and the other

end to Ethernet switch/hub*.

2. Connect PDA to the EA104 USB port**.

3. Connect the power adapter to rear socket of the EA104, then into the wall outlet.

If power is present, the EA104 will proceed with normal power on sequence - self

test and boot up sequence within 25 seconds; once the Power LED is solid in

color on the front panel, the unit is ready.

• If the unit has a problem, the power LED will flash quickly.

• If the network connection has a Link, the Ethernet LED will blink green.

• If USB devices are connected & recognized by the EA104, the

corresponding LED will illuminate on the front panel.

To shut down the EA104, disconnect the AC power adapter. Do not shut down the

EA104 when there is a PDA performing data communications since this may

cause data to be lost.

Notes:

* In a non-DHCP environment, the system administrator must set up an enclosed

DHCP network by accessing the EA104 configuration using the browser-based

AdminTool.

Clarinet Systems, Inc.

http://www.clarinetsys.com

Page 7