ABB M4M 커미셔닝 매뉴얼 - 페이지 5

{카테고리_이름} ABB M4M에 대한 커미셔닝 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB M4M 10 페이지. Firmware update

FW update procedure via EPiC desktop

A. Make sure you have a MyABB account. If not, please register on MyABB to

activate an account.

B. Open EPiC desktop in the "Scan" tab

C. Configure the scanning via communication protocol

TIP: In case of Modbus master device in the RS-485 architecture

(e.g. PLC), the master should be disabled in order to use EPiC

desktop and perform the FW update

1. Via Modbus RTU (M4M Modbus)

Click on "Configure" under Serial port.

Select port name, baudrate, parity, slave addresses of all devices

connected via Modbus RTU to be updated.

Press "OK".

M 4M FIRM WAR E UPDATE

5 /1 0