Clarinet Systems SyncHUB ES608 매뉴얼 - 페이지 3

{카테고리_이름} Clarinet Systems SyncHUB ES608에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarinet Systems SyncHUB ES608 9 페이지. Ethir lan product, infrared connectivity for handheld devices
Clarinet Systems SyncHUB ES608에 대해서도 마찬가지입니다: 사양 (4 페이지), 사양 (2 페이지), 매뉴얼 (13 페이지), 사양 (4 페이지)

페이지 인쇄

New EthIR LAN purchased with RADIUS option will have RADIUS disabled when we ship the

product. Followings should be configured by your network system admin with Clarinet's Windows

Configuration Tool version later than 1.12 (Palm Configuration Tool does not support RADUIS

configuration):

1. Primary RADIUS server IP address. This is the primary RADIUS server. UDP port

1812 is used for authentication and UDP port 1813 is used for accounting.

2. Secondary server IP address. The backup server is used if EthIR LAN cannot

communicate with the primary server. The secondary server uses the same NT domain

name and secret as the primary RADIUS server.

3. Domain name, up to 31 characters. This is for non-Windows devices to access the network

in Windows NT domain environment.

and the user name is John, then "XYZ_DOMAIN\John" is sent to the RADIUS server.

non-NT domain environment or Windows network without a domain, leave this field blank or

you can un-check the "Microsoft NT server" check box.

4. Shared Secret, up to 15 characters. This is the shared secret both stored on EthIR LAN

and RADIUS server.

5. Enable Authentication check box, provide system admin to temporarily enable/disable

EthIR LAN RADIUS support. If authentication is enabled, you must select the correct

authentication protocols, MS-CHAP, CHAP and PAP. If your RADIUS server does not

support MS-CHAP, un-check MS-CHAP, otherwise your PDA device login will fail.

6. Enable Accounting check box. If un-checked, EthIR LAN does not send out accounting

request and thus speed up time required to make a connection. Otherwise, accounting

information will be sent to the server in the beginning and the end of the PDA connection.

The way to tell if an EthIR LAN supports RADIUS is by using our Windows Configuration Tool,

search and find the EthIR LAN, click on "Edit Configuration" button, a RADIUS configuration tab

will be displayed. You can configure RADIUS with this tab. Once you change the configuration,

you need to update the NVM and reboot the switch to take effect.

NOTE: You need Windows Configuration Tool version later than 1.12 for RADIUS support

Clarinet Systems, Inc.

For example, the NT domain name is XYZ_DOMAIN

This shared secret is used for both the primary and secondary server.

For