Firestar vi40 빠른 시작 매뉴얼 - 페이지 14

{카테고리_이름} Firestar vi40에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Firestar vi40 15 페이지. Dual cooled laser

Firestar™ vi30/40 Dual Cooled Laser Quick Start Guide

Initial Start up without a UC-2000 Controller (Continued):

21.

Restore power to the laser and turn on the +48 VDC power supply. Turn on the +48 VDC power

supply. The laser's PWR LED should illuminate green. After a five-second delay, lasing is enabled

when a PWM Command signal is received.

22.

Set your PWM controller to a frequency of 5 kHz (at a +5 volt level) and ensure that the controller's

duty cycle is set to zero percent output (0.0%).

23.

Apply a Laser Enable signal to the DB-9 I/O connector. The yellow RDY lamp turns on to indicate

that, after a five-second delay, lasing is enabled when a PWM Command signal is received. Lase

LED will illumate red.

24.

If your laser fails to lase, reference the laser's Troubleshooting Section within the Operation Manual,

SYNRAD website for more information or contact SYNRAD support.

Pin 5

Pin 9

READY

LED.

Pin 1

Pin 6

POWER LED.

vi30/40 Dual Cooled QSG Version 2.1

LASE LED.