Firestar vi40 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Firestar vi40에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Firestar vi40 15 페이지. Dual cooled laser

Firestar™ vi30/40 Dual Cooled Laser Quick Start Guide

Laser Unpacking (Continued):

Note: IF using the FH Flyer marking head with your laser, go to the

and reference the

Note: IF not using a SYNRAD marking head OR mounting kit with your laser, see the section below.

Readying your Laser for use:

Failure to remove the aperture seal can damage your system!

SHUTTER

SWITCH

LASER EXIT

APERTURE

DP POWER

CONNECTOR

Important

SYNRAD does not recommend mounting lasers in a vertical, (head and/or tail down)

Note:

position. Please contact the factory for limitations as a vertical orientation increases the risk

of damage to the lasers optics.

Consult the factory for further mounting angle guidance outside >75% from the horizontal. When mount-

ing the laser to a baseplate, use only one metric or SAE fastener per mounting tab on the baseplate. Do not

use any type of jackscrew arrangement as this will twist the baseplate and may distort the tube.

FH Flyer & WMPv6 QSG

Failure to

remove can

damage the

APERTURE

laser!

SEAL

Invisible laser radiation

(Fan-Cooled ti60 Shown)

Mounting & FH Flyer Quick Start Guide

located on our website.

AVOID EXPOSURE

is emitted from

this aperture.

vi30/40 Dual Cooled QSG Version 2.1

OPTICAL

ACCESSORY

MOUNTING (x6)