Caldura ICM300 사용 설명서 - 페이지 4

{카테고리_이름} Caldura ICM300에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Caldura ICM300 8 페이지.

Cleaning

Before cleaning, you MUST unplug the mains power supply from the

wall, AND remove the plug from the main unit.

Twist the lid anti-clockwise to release it from the main unit.

Remove the paddle from the motor mechanism by pulling.

Release the paddle motor from the lid by pressing the push button.

The upper and lower lid parts can now be separated by pinching the

two fixing lugs together.

A damp soapy sponge should be used, if required, to clean the

paddle drive shaft on the paddle motor. DO NOT immerse the

paddle motor in water.

The paddle, upper and lower lid can be cleaned using warm soapy

water. The parts are NOT dishwasher safe, but are easily cleaned

by hand immediately after use.

The aluminium bowl can be cleaned by holding the main unit under

warm running water whilst cleaning with a soapy sponge. DO NOT

immerse the main unit in water, and be very careful not to allow

water into the main unit through the ventilation grills.

Important: If any amount of water accidentally enters the main unit

during cleaning, remove as much as possible, and then leave in a

warm place to thoroughly dry out for at least 48 hours. The main unit

runs at a low voltage, so water ingress would not cause a safety

issue, but the electronics within the unit would most certainly be

damaged if it is operated when wet.

www.caldura.co.uk

ICM300/14042016